PIT-RADWAR S.A. Oddział Wrocław
|| Home || Contacts || Site map ||   Wersja polska ||
  
Company
 About company
 Quality politics
 Contacts
 News
 Sales condition
 Equipment
Products
 Reed switches
 Reed sensors
 Reed relays
 Microwave tubes (TWT)
 Microwave amplifiers
 Radar subsystems and components
Service
 Service
Documentation
 Data sheets (pdf)
 Test coils
Support
 Application
Home » Aplication
Aplication
Cutting and bending

Distance between place of activity and glass-metal seal less than 3mm is not advice to protect connection before damaging. Even the force of mounting should be less than 0,9N.
If bending is necessary, reed switch should be protected from transfer a stress to glass-metal point (draw no 1). If cutting is necessary, please do it very carefully and distance should be not less than 3 mm (draw no 2).
Important - Pull-in Ampere Turns are changing after cutting and bending.
Draw 1 - bending   Draw 2 - cutting
Bending   Cutting
back to top  

PIT-RADWAR S.A.
ul. Poligonowa 30, 04-051 Warszawa

Wroclaw Division: ul. Krakowska 64; 50-425 Wroclaw
tel. (+48) 71 342-50-41; fax (+48) 71 342-58-59; e-mail: sales@dolam.pl